What Size Screwdriver For Xbox One Controller

Introduction

This guide will teach you how to remove the buttons.

• Remove the battery pack comprehend.

• Remove batteries.







• Nosotros recommend using a nylon spudger for this step. A metal spudger is shown.

• Grip the controller firmly to remove the side handles, wedging a spudger into the seam between the forepart and handle plates.

• Pry the side plate away from the forepart plate past moving the spudger back and along. Yous will demand to exercise this all the mode effectually the side plate'southward seam.

• There is a hidden screw located in the middle of the controller behind the label.

• Use a screwdriver and punch a hole directly in the eye of the label.

• Yous may besides elevator the label if you do not want to puncture it.

• Remove the v 10mm screws located on the back of the controller using the T8 Security Torx Screwdriver.

• Remove the backplate.

• Remove the faceplate.

• Y'all may let the rumble motors hang freely out of their sockets.

• De-solder the soldered joints while belongings the red and blackness wires downwards on the meridian motherboard.

• De-solder the black and gray wires that are attached to the height motherboard.

• Remove the rumble motors and fix them aside.

• Be careful while using the soldering atomic number 26 non to harm other components or hurt yourself.

• For information on how to solder, click here.

• Unscrew the 2 7mm T6 screws located near the rumble motor sockets.

• Firmly grip sides of motherboard most the middle.

• Elevator upwards while slightly wiggling the motherboard forward and backward.

• Lifting the motherboard volition crave some force.

• Remove the six T6 Torx screws located on the bottom motherboard.

• Remove the bumpers past prying them off of the pegs that secure them, using a spudger. They are located on the front end and back of the controller.

• A standard nylon spudger is recommended for this step. Using a metal spudger well-nigh the motherboard as shown risks damaging your device.

• Lift the piece surrounding the Home push button off of its pegs.

• Pry information technology off of the other side, using a spudger on the pins.

• A standard nylon spudger is recommended for this step. Using a metallic spudger virtually the motherboard as shown risks dissentious your device.

• Removing this piece may require a lot of force.

• Remove the bottom motherboard.

• Remove the safe backing to the buttons.

• With the buttons facing down, push them up out of their housings, and remove.

Conclusion

To reassemble your device, follow these instructions in opposite social club.

Team

Embed this guide

Choose a size and copy the code below to embed this guide as a small widget on your site / forum.

Preview

What Size Screwdriver For Xbox One Controller,

Source: https://www.ifixit.com/Guide/Xbox+One+Wireless+Controller+Buttons+Replacement/36845

Posted by: carrollboremat.blogspot.com

Share this post